Perreaux SXP2 - Manual (Page 19)

18
10 10 10 10 Troubleshooting Guide
Please use this guide if you are experiencing any problems with
the SXP2 in your system. It will provide possible solutions for
some given symptoms.
There is no
output from
my system
Interconnect cables not connected
Make sure that the input and output interconnect cables are
plugged in and are connected to the respective RCA sockets on
the rear of the SXP2.
Source not turned on
Check that your source component is plugged in to the mains and
the power is turned on.
Source not set to play
Ensure that your source component is playing the recording you
would like to listen to, and that pause is not pressed.
No volume setting
Make sure that the volume on your SXP2 is set to a suitable
level.
SXP2 set to incorrect input
Confirm that the input on your SXP2 is connected to the
appropriate source output.
Loud speakers not connected
Check that your loud speakers are firmly connected via cables
into the binding posts on the rear of the SXP2.
I can hear a
hum coming
through my
loud
speakers
Input sockets and/or output binding posts corroded
Check that the input and output RCA sockets and binding posts
on the rear of the SXP2 are free from corrosion.
Interconnect cables damaged
Make sure that the integrity of your interconnect cables is sound
and they are firmly connected to your source and the SXP2.
SXP2 is close to external interference
Check the proximity of your SXP2 to any possible source of EMI
and/or RF interference, for example computers, televisions,
amplifiers, speakers, etc. Ideally the SXP2 should be placed as
close as possible to your source.