Tascam VL-X5 - Manual (Page 8)

8
TASCAM VL-X5 Owner's Manual
Rear panel
1 XLR INPUT
This jack accept XLR input connection, wire either balanced or unbalanced.
The signal of XLR INPUT is summed together with TRS INPUT through a balanced input amplifier.
So, either may be used as an input or mixed together. Input specifications apply to both inputs.
The INPUT CONNECTIONS wiring chart of XLR connector is following:
Pin 1: GND
Pin 2: HOT
Pin 3: COLD
2 TRS INPUT
This jack accepts a TRS connector, wire either balanced or unbalanced.
For balanced wiring, a 3-conductor TRS plug is necessary. The INPUT CONNECTIONS wiring chart of TRS
connector is as following:
Tip: HOT (+)
Ring: COLD (-)
Sleeve: GND
Unbalanced wiring works with either a 2 or 3-conductor TRS connector. A 2-conductor TRS plug automatically
ground the minus signal input, whereas a 3-conductor TRS plug wired unbalanced provides the option of leaving the
minus open or grounded. We recommend that you grounded the unused input.
The TRS INPUT is summed together with XLR INPUT through a balanced Input amplifier.
So, either may be used as an input or mixed together. Input specifications apply to both inputs.
3 VOLUME Control
Use the Volume Control to set the output sound
pressure from VL-X5 to proper level required.
4 POWER LED
When power of VL-X5 is on, the LED will be light up. When power of VL-X5 is off, the LED will be turned off.
1
2
3
4
5
6
7
9
8
< MIN > < MAX >
Rear panel