TVS electronic JUS' BILL RP-35 - Manual (Page 7)

6
While pressing the paper feed switch for more than 10 seconds after the printer in turned on, the self
test mode is initiated.
The printer self test includes a listing of the current default settings, read and write test of internal RAM,
checksum test of internal program memory, loop back detection statement, a staggered dot line, a few
lines of rotating character set, and a diagnostic report.
The printer then enters into the On-Line mode.
Configuration Setup
When the paper FEED switch is pressed and released instantly as the power is applied to the printer, the
printer will print the current printer configuration settings along with the DIP switch information.
If the printer setup needs to be changed, turn the Power Off before changing the setting.
The printer will be setup at the factory as follows;
Printer is setup as follows:
Model : Jus' Bill RP-35
Firmware : Ver X.XX
Interface : Serial
Emulation : Epson TM-U200
CR Character : CR=CR only
Flow Control : DTR/DSR
Data Bits : 8 Bits
Parity : None
Baud Rate : 9600
CPL : 40/33 Char / Line
Two Color : Installed
Auto Cutter : Installed / Not Installed
Journal : Installed / Not Installed
3. Self Test