Toshiba SD-K530SU - Manual (Page 36)

The remote control can be compatible with various
brands of TV/Cable box/DSS satellite receiver by setting
their control codes. The TOSHIBA code has initially
been set to control TOSHIBA TVs.
Setting TV Control Codes
1. Press TV to set the remote control operating
your TV.
2. While holding down PROGRAM button, enter
the two digits of your TV’s brand code (listed on
page 37) using number buttons.
3. Release PROGRAM.
By pressing You can
POWER Turn the TV on or off.
CH/TRK +/– To select TV channels in the upper
or lower direction.
VOL +/– Adjust the volume of the TV.
Number buttons To select TV channels.
When selecting channels 1 to 9,
first enter 0 and then the desired
number.
100 To substitute for 100 channel key.
DISPLAY To turn on or off TV’s screen
display.
INPUT SELECT Switch the TV’s input source
between the TV and other input
sources.
Note
For some brands, several control codes (brand
codes) are allocated. Try each of them until the but-
tons work on your TV.
If you replace the remote control’s batteries, set the
brand code again.
DISPLAY
INPUT SELECT
TV
POWER
PROGRAM
Number
buttons
100
CH/TRK, VOL
ENTER
Important
Some TV’s may not respond to all the operations
above, or may not be operated at all with this
remote control. In this case, operate your TV with
its own remote control.
36
Controlling Your TV with the Supplied Remote