Toshiba E.STUDIO e-STUDIO 523 - Manual (Page 125)

123
4
5 Specify the following items as required.
• DHCP (IP Address)—Select whether or not the IPv6 address which is issued from the DHCPv6 server is used
for this equipment. Press the [ENABLE] button to use the address, or [DISABLE] button to not use it.
• DHCP (OPTIONS)—Select whether or not the optional information (IPv6 address for the DNS server, etc.)
except the IPv6 address for this equipment, which is issued from the DHCPv6 server is used on this equip-
ment. Press the [ENABLE] button to use the information, or [DISABLE] button to not use it.
• In “AUTO” mode, you cannot assign “IP ADDRESS”, “PREFIX” and “GATEWAY” manually.
• Either “DHCP (IP Address)” or “DHCP (OPTIONS)” must be in “ENABLE” mode.
6 Press the [ENTER] button.
• Returns you to the NETWORK menu.
7 Continue to another network setting if required, then press the
[APPLY NOW] button.
• The “NETWORK INITIALIZING” message is displayed and this equipment starts initializing the network inter-
face card to apply the changes.
If Duplicate Address Detection (DAD) detects duplicate addresses, the message “IPv6 ADDRESS CONFLICT” is
displayed on the touch panel.