Toshiba kV-9168A - Manual (Page 9)

RECORDING OPERATION
PREPARATION
INTRODUCTION
PLAYBACK OPERATION
NOTICE
A Word on the Exclusive 3N-100AAS
Battery Pack
The nickel-cadmium battery pack (3N-100AAS) is used for
power source of the built-in clock and memory circuit.
Charging the Battery Pack
1. Turn on the power of the VCR.
2. The battery pack in the VCR is charged.
Battery Installation
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
Specification of Battery
i
Temperature
For charging
: 0°C to 80°C
For operating : –20°C to 80°C
For storing : –30°C to 80°C
i Charging time : more than 48 hours
Notes:
i Use only for this VCR.
i Do not dispose of the batteries into fire.
i Do not short circuit the terminals.
i Do not modify or disassemble.
i Avoid dropping, unnecessary shocks.
8
Connector
RED wire
Battery pack
Installation:
1. Install the battery pack placing the red wire upside, and
connect the connector on the battery pack to this VCR.
Make sure the polarities (+) and (–) are correct.
2. Close the battery cover.
Note:
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.