Top Innovations HANDYMENDER SP-400 - Manual (Page 4)

7
3. Pull at least 2 inches of thread tail through the needle prior to
starting to sew.
4. Hold HandyMender in right hand; press power switch with your
thumb; use your left hand to guide the fabric .
5. When pivoting or turning a corner, the needle must be lowered
into the fabric.
How to Finish the Seam
1. When finished sewing a seam, raise the Needle Arm
by turning Hand Wheel. Then, use the back of the
Seam Ripper to pull the thread out about 3 inches; cut
leaving about a 3 inches tail.
8
2. Turn the Hand Wheel, lowering the needle into the fabric.
Continue to turn the Hand Wheel until Needle Arm is again
at its highest position.
3. Lift up the Presser Foot and take off the fabric to the left. Be
careful not to pull the thread or the seam will ravel.
4. The top of the fabric will have a 3 inches thread tail and the
bottom will have a small loop.
5. Turn to the bottom side of the fabric and with the backside of
the Seam Ripper inserted into the loop; pull the thread
through the fabric to the bottom side.