Toshiba CN32V71 - Manual (Page 15)

9
Ref
er
ence
W
elcome to Toshiba
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V
’s
F
eatur
es
Appendix
Index
Programming the remote control to learn
another remote control’s operating codes
This remote control is capable of learning operating codes from most
infrared remote control transmitters. If you set up the supplied remote
control to learn the operating codes of one of your existing remote
controls, then you will be able to use the supplied remote control to
operate both your new Toshiba TV and your existing equipment. The
21 shaded buttons shown on the remote control illustration to the
right may be used as learning buttons.
To learn the operating code of another remote control:
1. Set the TV/CABLE/VCR/AUX switch to the AUX position.
2. Place the supplied remote control and the remote control trans-
mitter to be learned head to head, approximately 1 to 3 inches
(3 to 8 cm) apart.
LIGHT MUTE
TV/VIDEO
TIMER
RECALL
POWER
CH
1 4
2 5
3 6
TV CABLE VCR AUX
POWER
1
2
3 Head to head
1 - 3 inches apart
Supplied remote control Remote control to be learned
3. Press and hold RECALL and ENTER at the same time to start the
learning mode.
The Learning Indicator will blink.
4. Hold down the Learning button you desire (choose one of the
shaded buttons shown in the illustration to the right) on the
supplied remote control until the Learning Indicator lights.
5. Hold down the button of the function to be learned on the other
remote control transmitter for about three seconds until the
learning indicator starts blinking.
If the Learning Indicator blinks rapidly, the supplied remote
control cannot learn the operating code or an error has occurred.
Repeat steps 4 and 5 above to try again.
6. Repeat steps 4 and 5 for each function you would like the sup-
plied remote control to learn.
7. Press EXIT to leave the learning mode.
8. To verify that the supplied remote control learned the operating
codes, try using it to operate the equipment. If the equipment
does not operate as you expect it should, repeat steps 1 through 7.
If necessary, try changing the distance between the two remote
controls before attempting the learning process again.
9. Reset the TV/CABLE/VCR/AUX switch to the TV position to
control the TV.
CH RTN
ADV/
PIP CH
ADV/
PIP CH
LIGHT
MUTE TV/VIDEO TIMER
RECALL
POWER
CH
VOL
Enter
ENT
PLAY PIP
REC
STILL LOCATE SWAP
TV/VCR REW FF
STOP SOURCE
FAV FAV
EXIT
1
4
7
2
5
8
3
6
9
0 100
Exit
POWER
MENU/
ENTER
STROBE
PREVIEW
FAVORITE
TV
CABLE
VCR
AUX
Learning
Indicator
Recall