Tonka Playskool - Manual (Page 4)

© 2006 Hasbro.
All Rights Reserved.
TM & ® denote U.S.
Trademarks.
FCC STATEMENT
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in
a residential installation. This
equipment generates, uses and
can radiate radio frequency
energy, and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interference
to radio or television reception,
which can be determined by
turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and the
receiver.
• Consult the dealer or an
experienced radio/TV technician
for help.
Tonka.com
Questions? Call: 1-800-PLAYSKL
Locate battery compartment
cover on top of REVVIN’
BEEPIN’ WHEEL. Use a Phillips/
cross head screwdriver (not
included) to loosen screw in
battery compartment cover
(screw remains attached to
cover). Remove cover. Remove
exhausted batteries and
replace with 3 x 1.5V “AA” or R6
size batteries. Alkaline batteries
recommended. Replace cover
and tighten screw.
TO REPLACE BATTERIES
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and
be sure to insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
Product and colors may vary.
91056 PN 6673920000