Charging the battery/ac operation – Texas Instruments TravelMate 2000 User Manual
Page 51
Charging the Battery/AC Operation
3.
After the battery is completely discharged, recharge the battery completely using the AC
Adaptor.
a.
Plug the female end of the supplied ac cord into the inlet on the AC Adaptor body.
b.
Plug the male end of the ac cord into a grounded outlet. Use a grounded plug
adaptor if necessary.
c.
Plug the cord from the AC Adaptor into the jack on the rear panel of the computer.
The Charge indicator on the front of the computer blinks while the battery is charging, then illuminates when
the battery is 90 percent charged. The battery takes about 2 hours to completely charge.
4.
Allow the battery to fully discharge again using the computer normally on battery power.
5.
Recharge the battery completely a second time. Your battery is now conditioned and able
to achieve maximum life.
3-8 Setting Up