Topcom 2500 - Manual (Page 6)

6 Topcom Baby Viewer 2500
Topcom Baby Viewer 2500
Once the baby unit and parent unit have been switched on, the display of the parent unit must
show the captured video from the baby unit and the link indicated LED (6) on the parent unit
will illuminate green.
If there is no connection between Baby- and Parent unit, ‘OUT OF RANGE’ will be
displayed. Check the power on both units or move the parent unit closer to the baby
unit to establish the connection.
5 Using the Baby Viewer 2500
5.1 Fine tuning
• Place the camera in a convenient location, point the
lens of the camera to the observation area.
• Adjust the angle by rotation the baby unit.
Do not place the camera within the babies reach!
5.2 Fixing the camera
• Use the crib connector to fix the baby unit to the crib.
(See illustration)
5.3 Night Light
• Press the Night Light button (19). The night light (18)
will illuminate.
5.4 Night vision
The camera has 9 high-intensity LED’s for picking up clear
images in the dark. When the build in photo sensor
measures the ambient light level as low, the LED’s will
automatically activate.
The image changes automatically into black and white mode under the night vision
mode.
5.5 Setting the Parent - Unit display brightness
• Press the Brighthess Low button (16) to make the display darker.
• Press the Brightness High button (17) to make the display brighter.
5.6 VOX function
• Press the VOX-button (8) on the side of the monitor. This will turn off the display, but the
VOX indicator (2) will turn on.
In VOX mode, the display will turn on when it is activated by the babies voice or other
sound around the baby unit. It will turn off again after 30 seconds.
• Press the VOX-button (8) again to turn off VOX - mode. The LCD will be on continously.