TANDBERG Gatekeeper - Manual (Page 84)

TANDBERG Gatekeeper User Guide
Page 84 of 105
16.3. Command
The command root command,
xcommand
, is used to execute commands on the Gatekeeper.
To list all
xcommand
s type:
xcommand ?
To get usage information for a specific command, type:
xcommand <command_name> ?
16.3.1. AllowListAdd
xCommand AllowListAdd <allowed_alias>
Adds an entry to the allow list, used by the registration restriction policy.
allowed_alias
can either be a specific alias, or use the wildcards
?
(for a single character) and
*
(for a single character or string of characters) to pattern match a group of possible aliases.
16.3.2. AllowListDelete
xCommand AllowListDelete <index>
Removes the pattern with the specified index from the allow list.
Allow list entries can be viewed using the command
xconfiguration Gatekeeper
Registration AllowList
.
16.3.3. Boot
xCommand Boot
Reboots the Gatekeeper. This takes approximately 2 minutes to complete.
16.3.4. CallTransfer
xCommand CallTransfer Call:<call_index> Leg: <1/2> Alias: <alias>
Attempts to transfer the half of the call identified by the call index and leg to the given alias.
Call and leg indices may be identified using
xstatus calls
.
16.3.5. CheckBandwidth
xCommand CheckBandwidth <node1> <node2> <bandwidth> <calltype>
This is a diagnostic function for verifying bandwidth control.
Node1
Node2
The case-sensitive names of the nodes.
bandwidth
The required bandwidth.
calltype
Must be one of
Traversal
,
Routed
or
Direct
16.3.6. CredentialAdd
xCommand CredentialAdd <username> <password>
Adds the given username and password to the local authentication database.