Toshiba 19A20 - Manual (Page 14)

14
Set up
Basic Operation
Advanced Operation
Reference Selection
Using V-CHIP Control
Some TV programs and movies includes signals that classify the content of the program (violence, sex, dialog, language).
The V-CHIP Control feature in this TV detects then signals and blocks the programs according to selections.
To use this feature, perform the following setup.
2
Press T (<) or S (>) to display the pin code
entering mode.
● Factory reset status
Set your 4 digit code by pressing the
Number buttons (0-9).
Example: To enter “1110”
Press 1, 1, 1, and 0 in
order.
● When the pin code is already stored
Press the Number buttons (0-9) to
enter the 4-digit pin code used to
block channels.
1 2 3
4 5 6
7 8 9
100 0 CH RTN
TV/VIDEO
POWER
RECALL MUTE
MENU EXIT
CH
VOL
CH
VOL
MENU EXIT
Number
buttons
s/t
T / S
1
Press MENU (then s or t on Remote)
repeatedly until “V-CHIP CONTROL” in
the Set up menu is displayed in purple.
If a wrong pin code has been
entered
this message will appear. Try to enter the
correct code again.
If you can not remember the pin code you
have stored, while in the pin code entering
mode, press the RECALL button four times
within 5 seconds.
The pin code you have stored will be re-
leased. (Factory reset status).
To return to the normal picture,
Press EXIT.
ENABLE BLOCKING : Y N
SET RATING
SET BLOCKING OPTIONS
NEW PIN CODE
BLOCK CHANNEL
MOVE[s t ] SELECT[T S ]
S
3
After about 1 second, the screen changes to
the V-CHIP CONTROL menu as shown.
Continue to set each item following the steps on the next page.
BLOCKING IS ACTIVE
PLEASE ENTER PIN CODE
1234
SELECT[0-9] END[EXIT]
BLOCKING IS RESET
PLEASE ENTER NEW PIN CODE
1110
SELECT[0-9] END[EXIT]
TV/CABLE: TV CABLE
CH PROGRAM
ADD/ERASE: ADD ERASE
V-CHIP CONTROL
LANGUAGE: ENGLISH FRANCAIS
ESPANOL
MOVE[s t ] SELECT[T S ]
S
S
S
INCORRECT PIN CODE
PLEASE ENTER PIN CODE
1235
SELECT[0-9] END[EXIT]
To select the V-CHIP CONTROL menu