M-AUDIO Fast Track USB - Manual (Page 3)

2 » English M-Audio Fast Track USB » User Guide
System Requirements
Windows
Minimum:
< Pentium II 350 MHz
< 64 MB RAM
< Windows XP
< CD-ROM drive
< Available USB 1.1 port
Recommended:
< Pentium III 500 MHz or faster
< 128 MB RAM or more
< Available USB 1.1 port
< Windows XP
Macintosh
Minimum:
< G3, G4, iMac, iBook or PowerBook with native USB
support
< 64 MB RAM
< CD-ROM drive
< Mac OS X version 10.2.8 “Jaguar” or later, or Mac OS X
version 10.3.4 “Panther” or later
Recommended:
< G3, G4, iMac, iBook or Powerbook with native USB
support (USB hubs are not supported)
< 128 MB RAM
< Mac OS X “Jaguar” version 10.2.8 or later
M-Audio suggests you also check the minimum system requirements for your software, as they may be greater than the above.
Front Panel Controls
1 . Input Level – Adjusts the gain level for the rear-panel XLR input (14).
2. Peak LED – Indicates presence of peak input level from XLR input. Lights when input signal approaches –3dB before overload.
3. Signal LED – Indicates presence of input signal from XLR input. Lights when input signal level approaches –40dB.
4. Input/Playback Mix Control – Controls the ratio of input signal to playback signal from your DAW. (When you record, you
should mute the track you’re recording. Otherwise, you’ll hear the analog input signal AND latency delayed recorded signal.)
5. Mono Switch – When pressed, this switch sums the input signals to mono for direct monitoring.