Toshiba N2PS CHASSIS 32HFX72 - Manual (Page 19)

– 17 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
PROGRAMMING CHANNEL MEMORY
The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL s or t button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.
Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.
TV/CABLE function
1
Press MENU, then press S or T until the SET UP menu
appears.
2
Press t (or s) until “TV/CABLE” is highlighted.
3
Press : or ; to highlight either “TV” or “CABLE”, whichever
you use.
CH PROGRAM function
1
Select “CH PROGRAM” following steps 1 and 2 above.
2
Press : or ; to start channel programming.
The TV will automatically cycle through all the TV or CABLE
channels selected by the TV/CABLE function, and store
active channels in the channel memory.
3
When channel programming is complete, you will see the
message to the right.
4
Press CHANNEL s or t to make sure the channel pro-
gramming has been done properly.
ADD/ERASE function
After performing the CH PROGRAM function, you can add
or erase specific channels.
1
Select the channel you want to erase using the CHANNEL
s or t button, or select the channel you want to add using
the Channel Number buttons.
2
Press MENU, then press S or T until the SET UP menu
appears.
3
Press t (or s) until “ADD/ERASE” is highlighted.
4
Press S or T :
To erase the channel
Press the button until “Erase” is highlighted.
To add the channel
Press the button until “Add” is highlighted.
5
Repeat steps 1 to 4 for other channels.
You have now completed the channel programming.
Note: The CHANNEL t/s buttons on the TV function as
the t/s buttons while a menu is on the screen.
∗ Please refer to owner's manual in detail.