Tascam CD-D1X4 - Manual (Page 18)

7 – Other functions
18
TASCAM CD-D1x4
Erasing discs
This applies to CD-RW media only. You cannot erase
CD-R discs that have been recorded.
1 Press the MODE key until the display shows:
2 Press ENTER . The display shows SURE ? .
Press ENTER for the next stage, otherwise
press MODE . If there is a slave drive into
which a target disc has not been loaded, the
display alternates:
with
3 Insert any discs to be erased in the slave
drives, close the trays and wait for the indica-
tors to go out. Then press
ENTER .
As the discs are erased, the display shows:
NOTE
You should take care that you do not leave any CD-RW
discs that you want to retain in the slave drive trays!
Finding out about your CD-D1x4
In the event of any questions about your CD-D1x4,
you may need to discover the drive type and firm-
ware versions of the five drives installed in the unit.
1 Press the MODE button until the display
shows:
2 Press ENTER , and then press MODE until the
screen shows:
3 Press ENTER . The display shows information
(maker, model and firmware version) about
the master drive (this may be different from
that shown here):
4 Press MODE to see similar information about
slave drives:
You can press ESCAPE to go up a level at any
time during this enquiry.
Finding out the main unit version number
1 Press the MODE button until the display
shows:
2 Press ENTER , and then press MODE until the
screen shows:
3 Press ENTER . The screen shows the model
and major firmware version (the number
shown may differ from the one shown here):
D I S C E R A S E ?
( C D - R W )
I N S E R T
T A R G E T D I S C
P R E S S E N T E R
T O S T A R T
D I S C E R A S E . . .
P l e a s e w a i t . . .
S E T U P
( M O D E C H A N G E )
> D R I V E I N Q U I R Y ?
M A S T E R
T E A C
M A S T E R
C D - 5 4 0 E
M A S T E R
3 . 0 A
D R I V E 1
T E A C
S E T U P
( M O D E C H A N G E )
> F / W V E R S I O N ?
C D - D 1 x 4
V e r 1 . 0 0