TANDBERG 880 MXP - Manual (Page 238)

TANDBERG 770/880/990 MXP
224
2 Audio Outputs
ƒ 1 output (line level) via RCA connector providing audio from far end in addition to dial
tones. This output is used by the monitor. This output also supports S/PDIF.
ƒ 1 VCR output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the VCR input) and audio from the far end. This output is
intended for connection to a VCR.
Audio output connector specification:
Connector label Audio outputs
Signal type Unbalanced
Connector (codec) Female RCA/phono, sleeve-ground,
centre-signal
Output impedance 680 ohms
Max output level when set
to maximum output level
and volume control set to
max.
Max output level when set
to minimum output level and
volume control set to max. 15.5 Vpp
1.2 Vpp
Range, menu adjustable
output gain 22.5 dB (16 steps of 1.5 dB)*
Volume control attenuation
(audio out 1) 0 to 21 dB + mute (steps of 1.5 dB)
* Additional attenuation is possible on room/loudspeaker audio output using the volume control
setting