TDK 3300 ICP - Manual (Page 26)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc Page 26
7.1 Feature Assignment
The table below shows how the keys of the 5220 IP Phone are mapped to key sequences
on the Wireless Telephone.
5220 key Feature
Wireless
Telephone
Shortcut & Key
Sequence
Trans/Conf Transfer or conference FCN + 1
Cancel Cancel FCN + 2
Message Voicemail FCN + 3
Redial Redial FCN + 4
Mute/Unmute FCN + 5
Superkey Superkey FCN + 6
Feature Key #1 Line appearance Line + 1
Programmable Feature Key 2-14
Programmable to either line
appearances or features. If Feature, the feature name
appears on the Feature menu
with a shortcut key
1 in the order
of assignment to a feature key.
FCN + 7
8
9
*
0
#
If Line, the line extension
appears on the Line
Appearance list, with a line
number that corresponds to the
order of assignment to a
feature key. Line + 2
3
4
5
6
7
8
9
Softkey1 Phonebook (Phbk) Softkey A
Softkey2 Programmable Softkey B
Softkey3 Programmable Softkey C
Hold Hold Softkey D
   
If an Open Application Interface (OAI) is operational, a function key
sequence will be assigned in the OAI configuration and will override any
function sequence established in the PBX.
1
Note: There may be more features programmed than there are available shortcut keys. In this situation, the feature may be activated
by using the Up, Down, Select buttons on the side of the Wireless Telephone.