Tangent AMP-50 - Manual (Page 14)

PHONO
POWER
HEADPHONE
AMP-50 AMPLIFIER
1
3
2
3
1
13
OPERATION AND FUNCTIONS
Turn on the amplifier by pressing the mains switch.
Press the standby button on the remote control to switch to standby
mode. The display will turn off and all functions will be reduced to a
minimum to make sure that the amplifier uses minimal power. When in
standby mode the unit only reacts to the standby button of the remote
control.
If you wish to turn off the unit to avoid any power consumption, you must
press the mains switch.
Protect the environment and turn off the unit after use.
Selecting the input source
Turn on the AMP-50.
Now you can call the input source that is active at the moment. Select Tuner to
listen to the radio, CD to listen to a CD, DVD, Phono, AUX1 or AUX2 if units have
been connected to these inputs.
If you do not know which input has been selected, the LCD display will clearly
indicate it.
Note: All inputs are analogue stereo inputs. It means that you cannot connect a
digital sound source through a digital cable (optical or co-axial).
On, Off and standby
2
+
+
Press the Phono, DVD, CD, Tuner AUX 1 or AUX 2
button on the remote control to select the
corresponding input.
Press the Phono, DVD, CD, Tuner, AUX 1 or AUX 2
button on the front panel to select the corresponding
input.
PHONO TUNER DVD CD AUX 1 AUX 2 FUNCTION