Toshiba TEC SL-9000N-FFH-QR - Manual (Page 57)

11. PROGRAMMED DATA VERIFICATION REPORTS
11. PROGRAMMED DATA VERIFICATION REPORTS
11- 1
11. PROGRAMMED DATA VERIFICATION REPORTS
The programmed data can be printed on journal paper. Before issuing these reports, load the journal
paper. The programmed data verification reports cannot be issued with any label. The keys to be
used in the following procedures are those on the numeric key pad, which is right side of keyboard in
the figure on page 5-3, but not on the programming keyboard.
How to access REPORT menu
Press the key to access th following display. Enter “5”, and the scale will enter the REPORT
menu. If the REPORT menu is protected, enter “5” and a password. (Refer to section 12)
ESC.
Set the table menu #.
Menu : REPORT
5 0
5 1
5 2
5 3
5 4
v
PLU programmed data
Commodity description
Speed key programmed data
Commodity and ingredient description
Grade lines
(See the next page)
<Menu>
0. PROG.
5. REPORT
1. REG 6. RESET
2. MARK DOWN 7.
3. REWRAP 8.
4. SECURITY 9.
u
u
u
PRT
*
Press:
5 5 Vendor name
5 6 Idiom