Toshiba 1202kit User Manual
Page 6
2
The following steps must be performed to properly install your DVD-RAM.
● Set drive’s jumpers
● Connect audio cable
● Attach IDE BUS cable
● Connect power cable
● Mount DVD-RAM
● Install CyberLink PowerDVD
™
software (used for viewing DVD movies)
● Install VOB InstantWritesoftware (used for recording CDs)
SETTING JUMPERS
The mode select jumpers are six (6) straight angle pins located on the rear of the
DVD-RAM. By placing a jumper on the pins, you can select the following func-
tions:
CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)
Mode Select Jumpers
In most installations, jumper should remain in MA (Master) position (factory
default). It is recommended that you install your DVD-RAM only on the second-
ary IDE BUS. If you are installing on primary IDE BUS, your hard drive would
then be the Master, and you should set your DVD-RAM to the Slave position (SL).
PLACING DVD-RAM INSIDE YOUR COMPUTER
Now that you have set your drive’s jumpers, you are ready to install your
DVD-RAM inside your computer.
☞
☞
☞
☞
☞
IMPORTANT: Disconnect power from your computer system before be-
ginning installation.
C
S
S
L
M
A