Setting up your tv, Changing on-screen display language, Selecting antenna input – Toshiba CN27V71 User Manual
Page 18: Changing the on-screen display language, Selecting the antenna input, Setting up y our t v, Using the ant/video button, Until the set up menu appears, Press
12
Setting up
y
our T
V
Setting up your TV
After you’ve installed the batteries and programmed the remote
control, you need to set some preferences on the TV using the menu.
You can access the menu with the buttons on your TV or by using the
remote control.
• When you make a menu selection, your changes occur immediately.
You do not have to press MENU or EXIT to see your changes.
• After fifteen seconds, the menu screen will automatically disappear if
you do not make a selection. Your changes will still be saved.
• When you are finished programming the menus, press EXIT.
Changing the on-screen display language
You can choose from three different languages (English, French and
Spanish) for the on-screen displays. Adjustment menus and messages
will appear in the language of your choice.
To select a language:
1. Press MENU, then press
x
or
•
until the SET UP menu appears.
LANGUAGE
TV/CABLE
CH PROGRAM
ADD/ERASE
ANT1/2
MORE
SELECT
END [EXIT]
ENGLISH
TV
START [ ]
ADD
ANT1
AUDIO
PREFER
SET UP
C.CAPT
PICTURE
TV/CABLE
PROG CAN
AJOU/EFF
ANT1/2
PLUS
ANGLAIS FRANCAIS
ESPAGNOL
TV
SUIVANT [ ]
AJOU
ANT1
AUDIO
PREFER
SET UP
C.CAPT
BOUGER [ ]
TERMINER [EXIT]
CHOISIR [ ]
LANGUE
PICTURE
2. Press
y
or
z
to highlight LANGUAGE.
3. Press
x
or
•
to highlight your desired language.
Selecting the antenna input
You can connect to two different signal sources by choosing the
antenna input (ANT 1 or ANT 2).
To select the antenna input:
1. Press MENU, then use
x
or
•
to highlight the SET UP menu.
2. Press
y
or
z
to highlight ANT 1/2.
LANGUAGE
TV/CABLE
CH PROGRAM
ADD/ERASE
MORE
MOVE [ ]
END [EXIT]
ENGLISH
TV
START [ ]
ERASE
ANT1 ANT2
SELECT[ ]
AUDIO
PREFER
SET UP
C.CAPT
PICTURE
ANT1/2
3. Press
x
or
•
to highlight either ANT 1 or ANT 2, depending on
the antenna terminal you wish to use.
Using the ANT/VIDEO button
You can monitor or change the signal source that is connected to the TV.
By pressing the ANT/VIDEO button on your TV, you can select the
VIDEO 1, VIDEO 2, ColorStream, ANT 1 or ANT 2 mode. The signal
source you are currently connected to will be displayed in purple.
CH RTN
ADV/
PIP CH
ADV/
PIP CH
TV
CABLE
LIGHT
MUTE TV/VIDEO TIMER
RECALL
POWER
VCR
CH
VOL
Menu
ENT
ENTER
PLAY PIP
STOP SOURCE
FAV
FAV
EXIT
MENU
RESET
1
4
7
2
5
8
3
6
9
0
100
Menu
Exit
MENU
VOLUME
CHANNEL
ANT/VIDEO
ENTER
Enter
C.CAPT