Tyco MX4428 - Manual (Page 110)

MX4428 MXP Engineering /Technical Manual Document: LT0273
MXP Diagnostic Terminal
Page 8-12 24 March 2006 Issue 1.5
13. Check the display on the terminal emulator to ensure the program runs and the new
version is installed. An example of the output on power up is shown below. Note that
some of this may scroll off the screen, however the “MXP Monitor version x.xx ...” line
should be visible and will enable you to verify the new version. If necessary type ST
<Enter> to see the version.
=====================================================
MXR Boot ROM V1.01. Address = 99, Switch 8 = 1
Valid application program in flash
Jumping to application program
**************************************************************
MXP Version 1.02 Powered Up
Address 99
Initial Power Up State
*** MXP monitor version 1.02 (c)2000 ***
(menu follows)
14. Write the new software version (1.02 in this example) on the label of the Flash IC, U2.