Taylor Router Tables & MagnaLOCK Plates - Manual (Page 2)

2
Fig. 5 Install Magna-LOCK ring insert
Fig. 6 Adjust ring flush with plate Step 5. Adjust ring levelers.
With the ring insert in place, insert the 3/32” hex key into
the four adjustment holes, and adjust as needed to level
the insert flush with the top surface of the plate, Fig. 6.
Note alignment between
insert and plate
3/32” hex key
CAUTION:
Always keep hands safely clear of the
router bit when installing or changing ring inserts.
Step 4. Install Magna-LOCK Ring Insert.
Orient the ring insert relative to the router plate as shown in
Fig. 5 and Fig. 6, then lower into the plate recess. The (4)
rare earth magnets are extremely powerful, and the ring
insert will SNAP into place.
TIP: The insert is keyed to fit only one way. If it doesn’t
align on the first try, flip it over and try again.
To remove the ring insert,
slide the 3/32” hex key
under the access hole,
and lift up, Fig 6A.
DO NOT push downward
on the hex key to remove
the insert, because this
can mar the surface of the
router plate. Lift upwards
instead.
Fig. 6A
Second: Lift UP
to remove insert
from plate
First: Slide 3/32”
hex key under plate
through access hole
Fig. 7 Install LS Positioner on INCRA offset style router tables
1/4-20 x 2 hex bolt (4)
NOTE: 1/4-20 x 2 hex bolt,
nut and washer are included
with the LS Positioner.
1/4” washer (4)
1/4-20 hex nut (4)
T-slots on LS Base
Step 6. Install LS Positioner.
Unlock the LS Positioner carriage clamp
and carefully slide the carriage out of the
LS Base. Install the (4) 1/4-20 x 2 hex
bolts, 1/4” washers and 1/4 -20 hex nuts
supplied with the LS Positioner in the
holes provided in your INCRA Router
Table as shown in Fig. 7. Now slide the
two T-slots on the LS Base over the
heads of the bolts. Refer to page 5 of
your LS Positioner owners manual to
determine the final position of the LS
Base relative to the center of the router
collet. Square the base to your table
edge, and securely tighten the fasteners.
LS Base
LS Base Positioning Note: The 24” x 36” offset router
table has been optimized for the LS17 Positioner. The 27”
x 43” offset table has been optimized for the LS25
Positioner. To achieve the maximum positioning range
available from either model, use the 2 sets of mounting
holes farthest away from the router cutout as shown in Fig.
7. When properly located, the LS Base will overhang the edge of the table by about 5”, which is permissible as long
as all 4 hex bolts are securely captured in the T-slots. The
extra mounting holes that are closer to the router cutout are
provided to allow installation of the LS Positioner closer to
the router cutout if desired. These extra mounting holes
on the 27” x 43” table also allow the LS17 Positioner to be
installed within range of the router on this larger table.
Adjustment hole (4)