Teac G-0s - Manual (Page 11)

11
Specifications
Clock outputs
44.1 kHz lines . . . . . . . . . . . . . 44.1 kHz, 88.2 kHz, 176.4 kHz
48 kHz lines . . . . . . . . . . . . . . . . . . . 48 kHz, 96 kHz, 192 kHz
PAL FILM lines . . . . . . . . . . 46.08 kHz, 92.1 6kHz, 184.32 kHz
UNIVERSAL CLOCK lines . . . . . . . . . . . . . . . . 100 kHz, 96 kHz
Terminals. . . . . . . . . . . . . . . . . . . . . . . . . . . BNC coaxial/75 Ω
Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . rectangular wave
Accuracy
Under ±0.05ppb (factory setting, ppb: 10 -9 )
Stabilized time of the output clock
If the main power to the Rubidium oscillator is first turned
on . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 minutes
If the G-0s is in standby mode and the Rubidium oscillator is
stabilized. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 seconds
MASTER/FREQUENCY MODE switched to output stabilized . .
Less than 10 seconds
Frequency input
Input. . . . . . . . . . . . . . . . . . . . . . . . 10 MHz (under ±10 ppm)
Rectangular or Sine wave, 1.4-5 V (peak to peak)
Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . BNC coaxial/75 Ω
General
Power supply . . . . . . . . . . . . . . . . . . . . . . . . AC 120 V, 60 Hz
Power consumption . . . . . . 75 W (maximum), 31 W (nominal)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18.5 kg (40.8 lbs)
External dimensions (W x H x D) . . . . . . . 442 x 155 x 351 mm
(17.4˝ x 6.1˝ x 13.8˝)
Accessories
Power cord x 1
Felt x 3
Warranty card x 1
Owner’s manual x 1
• Design and specifications are subject to change without
notice.
• Weight and dimensions are approximate.
• Illustrations may differ slightly from production models.
442mm
155mm
333mm
351mm