TANDBERG D1320202 - Manual (Page 12)

TANDBERG GW Data port Command Interface User Guide
12
SNMP SystemLocation: <S: 0, 70>
or
SNMP HostIPAddr [1..3]: <IPAddr>
---
parameters:
• Mode: < On/Off/ReadOnly/TrapsOnly >
• Community Name: Text string of maximum 16 characters.
• System Contact: Text string of maximum 70 characters
• System Location: Text string of maximum 70 characters
• Host IP Addr: The IP addresses of max 3 SNMP trap hosts
sub-commands:
• Mode enables or sets the mode of SNMP support
• Community Name is used to authenticate SNMP requests.
SNMP requests must have this ‘password’ in order to receive a
response from the SNMP agent in the gateway.
• System Contact, Used to identify the system contact via SNMP
tools such as HPOpenView or TANDBERG Management Suite
• System Location Used to identify system location via SNMP
tools such as HPOpenView or TANDBERG Management Suite
• Host IP Addr identifies the IP-address of the SNMP manager.
Up to three different SNMP Trap Hosts can be defined. Your
LAN administrator should provide the correct values for these
fields
Example of SNMP feedback:
*c xConfiguration SNMP Mode: On
*c xConfiguration SNMP CommunityName: "public"
*c xConfiguration SNMP SystemContact: ""
*c xConfiguration SNMP SystemLocation: ""
*c xConfiguration SNMP HostIPAddr 1: "127.0.0.1"
*c xConfiguration SNMP HostIPAddr 2: "127.0.0.1"
*c xConfiguration SNMP HostIPAddr 3: "127.0.0.1"
SSH Enables or disables SSH interface on the 3G GW
SSH Mode: <On/Off>
---
Example of SSH feedback:
*c xConfiguration SSH Mode: On
TELNET Enables or disables telnet interface on the 3G GW
Telnet Mode: <On/Off>
---
Example of TELNET feedback:
*c xConfiguration Telnet Mode: On
SystemUnit Sets the 3G GW name and password
SystemUnit Name: <S: 0, 50>
or
SystemUnit Password: <S: 0, 16>
---
Parameters:
• Name: Text string of maximum 50 characters
• Password: Text string of maximum 16 characters