Toshiba DR430KU - Manual (Page 37)

37 EN EN
Disc
Management
Recording
Playback
Introduction
Connections
Basic Setup
Editing
Function Setup
Others
BASIC RECORDING & ONE-TOUCH TIMER RECORDING
7 Press [STOP
C] to stop recording.
The recorded title will be included in the title list.
(Refer to “Guide to a Title List” on page 66.)
e.g.) DVD+R/DVD-RW/-R
Wait for a moment 90%
This operation may take
awhile to be completed.
6 Press [REC
I] to start recording.
“ I” will be displayed for 5 seconds.
I SP 1:53
Press [PAUSE F] to pause recording.
Press [PAUSE F]] or [REC I] again to restart
recording.
To set one-touch timer recording (OTR)...
This is a simple way to set the recording time in blocks
of 30 minutes.
Press [REC
I] repeatedly until the desired recording
time (30 minutes to 8 hours) appears on the TV screen.
One-touch timer recording will start.
0:30
(normal recording)
8:00 7:30
1:00
I 0:30
• To change the recording length during one-touch
timer recording, press [REC
I] repeatedly until the
desired length appears.
• To cancel one-touch timer recording within the
specified time, press [STOP C].
Note
• When you press [REC I], recording starts immediately and continues until the disc is full or you stop recording.
• When the unit clock has not been set, the space for a date and time of title names will be blank.
• You cannot change the recording mode during the recording pause mode.
Note for one-touch timer recording
• The remaining recording time will be displayed on the front panel display during one-touch timer recording. Press
[DISPLAY] to see it on the TV screen.
• Unlike the timer recording, you can perform the following operations during one-touch timer recording.
- Turning the unit into the standby mode (One-touch timer recording will be canceled.).
- Using [REC
I] or [STOP C] on the remote control.
• You cannot use the pause function during one-touch timer recording.
• When one-touch timer recording is finished and the power is turned into the standby mode, the unit will switch to
the timer-standby mode automatically if a timer recording has been programmed. Press [I/ y yON/STANDBY] to
cancel the timer-standby mode to use the unit continuously.