Tascam DA-302 - Manual (Page 18)

19
Section 6 : Playback
This function allows you to play back programs in a user-
specified sequence.
1
Select the deck with the SELECT 1/2 key.
2
Press the MENU key to show the following menu in
the time display.
PGM1 s01_EE
3
Enter the program number of the program you want to
play first with the UP/DOWN key.
PGM1 s01_03
4
To program the program you want to play back second,
first press the
> key and set the step number to "s02".
PGM1 s02_EE
5
Enter the program number of the program you want to
play back second with the UP/DOWN key.
PGM1 s02_05
6-6. Program playback
This function allows one or all programs to be played back
repeatedly.
·With one program repeat, the tape is automatically
rewound to the previous Start ID when a Start ID is
detected.
·For all program repeat, the tape is automatically
rewound to the beginning when the tape end is reached
or the End ID is detected.
1
Select the deck with the SELECT 1/2 key.
2
Press the MENU key to show the following menu in
the time display.
Repeat1 Off
3
Set to "Single" with the UP/DOWN key to engage the
One Program Repeat mode. Set to "All" to engage the
All Program Repeat mode.
… If the STANDBY key is set to ON in the One Program
Repeat mode, the Play-Pause mode is engaged at the
beginning of the program after one program has been
played.
6-5. Repeat playback
6
Up to 50 programs can be programmed in the same
way.
7
Press the EXECUTE key to start Program Playback.
… The last step is the step before the step in which "EE" is
shown in the program number input section on the
menu.
e.g.) In case of [PGM1 s03_EE], step 02 (s02)
is the last step.
… Checking the programmed sequence
Each time the > key is pressed while the program
menu (e.g.: [PGM1 s01_03]) is displayed, the
step number changes, allowing you to check the pro-
gram number.
(By pressing the
> key while pressing the SHIFT key,
you can check the previous step number.)
… Adding to or changing the programmed sequence
To add a program number, display the step number with
"EE" and enter the program number. Adding a program
number in the middle of the program sequence is not
possible.
To change the program number, display the program
number to be changed by pressing the
> key and enter
a new program number with the UP/DOWN key.
·To enter "EE", press the UP key and DOWN key
simultaneously or the CLEAR key on the remote
control unit.