Toshiba W-727 - Manual (Page 37)

37
RECORDING
DSS ® Satellite Receiver Set-up
1
Press PROG. to display the MENU screen.
2 Select “PRESET” using FF or REW,
and press ENTER.
3
Select “CABLE BOX/DSS” using
PLAY/x2 or STOP, and press
ENTER.
4 Select “DSS” using FF.
5 Select “OUTPUT CH” using PLAY/x2 or STOP, and enter
either of the following according to your connection.
Type A: the output channel number of
your DSS
® satellite receiver using
number buttons. (Usually 3 or 4. Check
the rear of the DSS
® satellite receiver.)
Type B: the line input mode “L1” using
I.SELECT.
6 Select “CONTROL” using PLAY/x2 or STOP, and set to “O n ”
or “OFF” using FF or REW.
O N : if your DSS ® satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
→
Go to step 7.
USE no C. Box DSS
OUTPUT CH 3 CH
CO n TROL Off on
BRA n D TYPE no. 36
Preparation
Select the video channel (3 or 4) or video input mode on the TV.
(Continued)
(Example)
E n D : PROG
USE no C. Box DSS
TV VCR
PROG. ENTER
TV/ VCR
POWER
CH/TRK
TV VOL
I.SELECT
REMAIN/ COUNTER DISPLAY COUNT RESET
SP/ SLP REC TIMER
SLOW PLAY/x2 PAUSE/STILL
REW F F
CANCEL
A.SELECT
EJECT
100
VCR Plus+ CH CABLE BOX
CM SKIP POWER
1 2 3
4 5 6
7 8 9
0
Number
buttons
I.SELECT
CURSOR
STOP
FF
PLAY/x2,
STOP
POWER
(CABLE BOX)
PROG.
ENTER
REW
CH
(CABLE BOX)
E n D : PROG
USE no C. Box DSS
OUTPUT CH 3 CH
CO
n TROL Off on
E n D : PROG
USE no C. Box DSS
OUTPUT CH 3 CH
CO
n TROL Off on
TO SET CH PUSH 0~9 KEYS
W-727/Eng (24-39) 2/28/02, 4:00 PM 37