TurboChef Technologies C3 - Manual (Page 24)

M A I N T E N A N C E
P R O B L E M A R E A
O R F A U L T C O D E
P O S S I B L E C A U S E ( S ) S U G G E S T E D R E M E D Y
F2 Low Temp Oven power interrupted.
Cooking platter restricting air flow.
Air nozzles on top of cooking
chamber are clogged.
Catalytic converter is clogged
and restricting proper air flow
circulation in the oven.
Circuit breaker tripped.
Blower motor not running.
Verify wall circuit breaker is on. Reset
breaker and then power oven back on.
Remove cooking platter and verify that holes
are not clogged with debris.
Remove cooking platter and filter (left rear
section of oven cavity) and clean.
Verify food items are not directly cooked on
the cooking platter, as excess grease particles
may accumulate on the catalytic converter.
Reference “Catalytic Converter” (page 21).
Refer to Troubleshooting steps (page 18)
prior to calling for service.
Refer to Troubleshooting steps (page 18)
prior to calling for service.
F3 Mag Curr Circuit breaker tripped.
Microwave circuit defective.
Place the oven into “Oven Off” mode
for 2 minutes, disconnect the plug for
minimum of 2 minutes, re-plug and
then press “Oven On” key.
Refer to Troubleshooting steps (page 18)
prior to calling for service.
F4 Monitor Oven cook door was opened while
oven was cooking.
Oven cook door switches are out
of order. Refer to Troubleshooting steps (page 18)
prior to calling for service.
Refer to Troubleshooting steps (page 18)
prior to calling for service.
F5 Mag Temp Blockage of cool air into the oven.
Rear cooling fan exhaust guard
is clogged.
Check for paper towels or anything that
may be obstructing cool air into the oven.
Check rear fan to see if it is free of debris.
Clean as required.
Refer to Troubleshooting steps (page 18)
prior to calling for service.
F6 EC Temp Blockage of cool air into the oven.
Rear cooling fan exhaust guard
is clogged.
Check for paper towels or anything that
may be obstructing cool air into the oven.
Check rear fan to see if it is free of debris.
Clean as required.
Refer to Troubleshooting steps (page 18)
prior to calling for service.
Note: All Fault Codes listed in bold will terminate a Cook Cycle upon discovery.
Note: Any fault occurrence during Cook mode will be logged in the Fault Counter.
Note: F6 fault code will not terminate a cook cycle, however it will alert the user of a possible air circulation problem.
20