Top Innovations SF-432 - Manual (Page 7)

Top Innovations, Inc.
A SSEMBLING THE
F ABRIC S TEAMER & I RON
7
SECURING WALL-MOUNTING BASE TO WALL
CAUTION: Be sure Wall-Mounting Base is located where small children will not
have access to the unit’s cords when it is mounted.
1. Select a location for Wall-Mounting Base. Be sure that Base will not prevent a door
from opening or closing properly, and that cords will not get closed in a door.
CAUTION: In order to avoid electrical shock, do not hang unit directly over an
electrical outlet.
2. Refer to FIGURE 1 below, which illustrates how to use included screws and anchors to
secure Wall-Mounting Base to wall.
NOTE: Keep in mind that the Fabric Steamer & Iron may be used while mounted
on the Wall-Mounting Base. Alternatively, the Base Unit may be removed and
used on any ordinary table top or other flat surface, and mounted on the Wall-
Mounting Base for storage purposes only.
FIGURE 1
10 Top Innovations, Inc.
U SING THE
F ABRIC S TEAMER & I RON
FILLING WATER RESERVOIR WITH WATER
NOTE: When water level is low, it is normal for water reservoir in Base Unit to emit
a pumping sound. Adding more water will eliminate the sound.
CAUTION: Be sure that power cord is not connected to an electrical outlet before
filling water reservoir with water.
1. Unscrew Water Reservoir Cap by turning it in a counter-clockwise direction
(FIGURE 4-A). This will expose the Water Reservoir Inlet.
2. Fill included Measuring Cup with water, then pour into water reservoir through Inlet.
NOTE: In order to prolong the life of your Fabric Steamer & Iron, it is
recommended that de-mineralized or distilled water is used to avoid mineral
build-up.
3. Repeat STEP 2 above, in order to completely fill water reservoir with 32 oz. (950 ml.)
of water.
IMPORTANT: Do not add detergents or other chemicals to water reservoir;
doing so may result in damage to the unit.
4. Place Water Reservoir Cap back onto Water Reservoir Inlet, and rotate it in a clockwise
direction to secure it back into place (FIGURE 4-B).
FIGURE 4
A B
Mount between 36” (91cm)
and 54” (137cm) from floor.