Trilogy Touch Technology 500-19-54 - Manual (Page 5)

500-19-54 Dual Channel Telephone Interface
Issue 1.2 Trilogy Communications Limited Page 5 of 19
1. INTRODUCTION
1.1 Safety Precautions
This equipment has been designed and tested to the highest safety standards. The following
precautions should be covered to ensure safe operation of the apparatus.
1.2 Transportation and Storage
Careful inspection of the unit must be made after it has been subject to transportation or
storage. Any serious damage, which could render it dangerous, must be acted upon to
safeguard any potential user.
1.3 Mains Connector and Plug
The supply lead plug shall only be inserted into a supply socket equipped with an earth contact.
Extension of the lead must include a suitable conductor for the protective earth.
This equipment must be earthed.
1.4 Fuses
Only the specified value and type of fuse must be fitted in the event of a replacement.
The brown supply lead (live) is fitted with a series fuse located in the mains connector fitted on
the rear panel. Should the unit be fitted with a two-pin plug then it is possible, if the supply is
reversed, for parts of the equipment to remain at supply potential after the fuse has ruptured.
1.5 Removal of Covers
Care must be exercised if the covers of the unit are removed. All internal live parts are covered
but the equipment should be disconnected from the supply source before repair or maintenance.
Should it be necessary to carry out adjustments with the supply voltage connected then this
work must be done by suitably qualified personnel.
Note that capacitors in power supplies and mains filters can be charged when the equipment is
disconnected from the supply. Before commencing work on the unit, these components should
be discharged in a safe manner.
It is important to note the designation of securing screws. These must be replaced in the
positions to which they were supplied to reduce the possibility of damage to circuit boards
mounted close to chassis securing screws.
CSA requirements
1) "The socket outlet shall be installed near the equipment and shall be easily
accessible"
2) "The Telephone Hybrid utilizes a AC power source; 90-250Vac, 50-60Hz,
0.25 Amps per cord"