Topcom BUTLER 1600 - Manual (Page 16)

16 Topcom Butler 1600/Twin/Triple/Quattro
Topcom Butler 1600Twin/Triple/Quattro
If you press and hold the INT key for 3 seconds you can talk with the 2nd handset
and external line at the same time (conference call)
– Or press the INT key again to return to the external call.
Æ Press the Line button to end the call.
9.2 Internal call (intercom)
• In standby press the INT key followed by the number (1-4) of the other handset.
• The other handset will start to ring. You can stop the ringing by pressing the Line
button .
• If the other handset answers the call by pressing the Line button you can talk
internally.
• Press the Line button to end the call.
10 Reset of the handset
This will undo all changes and set back all default settings (ringer volume, ringer melody,
etc...).
Press Menu button
Æ Use the Right button to scroll to ‘RESET’ and press OK Æ
Enter the pin code (0000) and press OK Æ The unit will go back to standby.
Default handset settings are:
Handset volume 3
Handset melody 9
Flash time Short
Dial mode Tone
11 Troubleshooting
Problem Possible cause Solution
No Display Batteries not charged Check the position of the
batteries
Recharge the batteries
No dialling tone Telephone cable not
properly connected Check the connection
of the telephone cable
Volume of conversation
partner too low Adjust the volume during the
conversation by pressing the
volume key
Handset ringer volume too low Adjust the ringer volume
Not possible to dial a number Wrong dial mode See “Setting the dialling mode”
to set the correct dial mode
All memories (redial, phonebook, call log,...) and handset name will not be
erased!