Transition Networks CBFTF10XX-15X - Manual (Page 3)

4
CBFTF10xx-15x
Tech Support: 800-260-1312 International: 952-941-7600 7am-6pm CST (GMT-6:00)
INSTALLATION -- Continued
Install the Twisted-Pair Copper Cable
1. Locate or build IEEE 803.2 ™ compliant 10Base-T or 100Base-TX cables,
with straight-through RJ-45 cable, and with straight-through RJ-45
connectors installed at both ends.
2. Connect the RJ-45 connector at one end of the cable to the RJ-45 port
connector on the Media Converter.
3. Connect the RJ-45 connector at the other end of the cable to the RJ-45
port connector on the other device (switch, workstation, etc.).
NOTE: The MDI (straight-through) or MDI-X (crossover) cable connection is
configured automatically, according to the network conditions.
RJ-45 port
on the Media
Converter
RJ-45 port
on the other device
(switch, work station, etc.)
Install the Fiber Cable
1. Locate or build IEEE 803.2 ™ compliant 100Base-FX fiber cable with
male, two-stranded TX to RX connectors installed at both ends.
2. Connect the fiber cables to the CBFTF10xx-15x Media Converter as
described:
•
Connect the male TX cable connector the female TX connector.
• Connect the male RX cable connector to the female RX connector.
3. Connect the fiber cables to the other device (another Media Converter,
hub, etc.) as described:
•
Connect the male TX cable connector the female RX connector.
• Connect the male RX cable connector to the female TX connector.
Connect the fiber cable
to the Media Converter
as shown. Connect the fiber cable
to the other device
(media converter,
hub, etc.) as shown
RX
TX
RX
TX
[email protected] -- Select the “Transition Now” Link for a Live Web Chat 5
INSTALLATION -- Continued
Power the Media Converter
The CBFTF10xx-15x Slide-in-Module Media Converter is powered through the
Point System™ chassis.
OPERATION
Status LEDs
Use the status LEDs to monitor the Media
Converter and the network connections.
FDPX (Fiber Duplex)
ON = full-duplex fiber connection.
Blinking = half-duplex fiber connection.
FLNK (Fiber Link)
ON = fiber link connection.
Blinking = fiber network activity.
PWR (Power)
ON = connection to external AC power.
TSPD (Twisted-Pair Speed)
ON = 100 Mb/s.
Blinking = 10 Mb/s.
TDPX (Twisted-Pair Duplex)
ON = full-duplex copper connection.
LED off = half-duplex copper connection.
TLKN(Twisted-Pair Link)
ON = copper link connection.
Blinking = copper network activity. CBFTF150
PWR FDPX FLNK
TLNK TSPD TDPX
RX
TX
100Base-FX
10/100Base-TX