Tricity Bendix BS 631/2 - Manual (Page 41)

BEFORE CLEANING THE COOKER ALWAYS
ALLOW THE COOLING FAN TO COOL THE
COOKER DOWN BEFORE SWITCHING OFF THE
ELECTRICITY SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your cooker,
check that they are suitable and that their use is
recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided.
CLEANING THE OUTSIDE OF THE
COOKER
DO NOT use abrasive cleaning materials or scourers
on the outside of the cooker, as some of the finishes
are painted and damage may occur. Regularly wipe
over the control panel and oven door using a soft
cloth well wrung out in warm water to which a little
liquid detergent has been added.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
CLEANING BETWEEN THE OUTER AND
INNER DOOR GLASS
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1. Open the oven door slightly to gain access to the
two cross head screws on the top of the oven
door.
2. Loosen the two screws using a Pozidrive
screwdriver.
3. Hold the door glass securely in place with one
hand, before removing the screws completely
with the other hand.
4. Using both hands, gently tilt the top of the door
glass towards you. Lift slightly to disengage the
locators from the two bottom brackets.
5. Clean the outer and inner glass using hot soapy
water or Hob Brite. Should the inner face of the
outer door glass be heavily soiled, it is
recommended that soapy water with a high
concentration of soap is used. To prevent
streaking, a glass cleaning spray may be applied
and the glass polished with a soft cloth. DO NOT
try to clean the aluminium foil which is inside the
door. The foil is there to help keep the door cool,
if it is damaged it will not work. Ensure that all
parts are well rinsed and thoroughly dry before
attempting to replace the outer door glass.
TO REPLACE THE OUTER GLASS
1. Holding the oven glass with both hands, gently
place the locators into the holes of the brackets
at the bottom of the oven door.
2. Push the top of the oven glass towards the oven
door, ensuring the screw location holes line up.
3. Hold the glass in place with one hand and insert
the cross head screws into the location holes
with the other hand. Give the screws one turn to
ensure the glass is secure.
4. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
DO NOT attempt to use the oven without the glass
being in place.
41
CARE AND CLEANING