Technics SC-EH680 - Manual (Page 13)

13
RQT6301
Control guide and preparatory steps
»
B Setting the time
This is a 24-hour clock.
The example shows how to set the clock for 16:25 (4:25 p.m.).
1
Press [
ê
/I] to turn the unit on.
2 1
Press [CLOCK/TIMER] to display “CLOCK”.
Each time you press the button:
CLOCK
>F PLAY >F REC > Original display
^------------------------------------------------------------}
2
Within 5 seconds
Press [SET].
3 1
Press [TUNING (
X
or
W
)] to set the time.
The time display can be changed in one minute units by tapping
the buttons, and quickly by holding down the buttons.
2
Press [SET].
The time is set and the original display is restored.
Displaying the clock
Press [CLOCK/TIMER].
The clock is shown for about 5 seconds.
Reset the clock regularly to maintain accuracy.
[A]
Turning DEMO off
A demonstration of the display is shown if you have not set the
clock.
You can reduce the power consumed in standby mode by turning
the demonstration off.
While the unit is on:
Press and hold [–DEMO] until “NO DEMO” is
displayed.
Each time you press and hold the button:
NO DEMO (off)
b DEMO (on)
B
1
2
3
1 2 3
H /I
? TUNING @
CLOCK/
TIMER
SET
SET
1
2
1
2
A
s DEMO
DEMO