Telex AUDIOCOM MS-2002 - Manual (Page 17)

17
Typically, a headset is connected to the front panel of the MS-2002, and the DIP switches are set to the monaural operation
(default setting) so both intercom channels are heard in the monaural headphones (binaural headphone operation is not
supported).
Beltpacks use less power than speaker stations, and you can daisy-chain more of them on a single cable run. Avoid very long
cable runs with daisy-chained speaker stations. This example shows how you would home run a SS-2002 speaker station when
the cable is very long. Also, set the Combine/Isolate switch to the Isolate position. With this setting, the two (2) intercom
channels are completely separate.
FIGURE 5. MS-2002 Typical Speaker Station and Belt Pack Connections.