True Manufacturing Company TR1RRI-1S - Manual (Page 12)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
10 10
INSTALLATION / OPERATION INSTRUCTIONS
Once the cabinet is in its final location and level the roll-
in ramp can be installed. The ramp has three slotted
holes in back. These slotted holes slide over three thumb
screws located in the front of the cabinet near the floor
(see image 1).
RAMP INSTALLATION FOR ROLL-IN CABINETS
1
3
2
4
DOOR SWEEP GASKET ADJUSTMENT
To adjust door sweeper gasket, loosen slotted thumb-
screws. The gasket can then be moved up or down and
side to side. The gasket should make some contact with the
ramp when the door is closing. This can be checked by
opening up the door 3-4” and allowing the door to close.
This process may have to be done several times before
securing the sweeper gasket bracket. Once gasket is prop-
erly adjusted, tighten slotted thumbscrews (see image 5).
5