Triax TSR 1000 - Manual (Page 22)

Menu Operations
19
4. Installation
After selecting the installation menu you
can see the window like beside.
In “Installation” menu;
1. Press [Channel Up/Down] to select
menu items among Antenna Setup,
Single Search, Multi Search, TP Scan,
Satellite List, TP List and Satellite
Guide.
2. Press [OK] to enter the selected item.
4.1 Antenna Setup
After selecting antenna setup another
window will be opened.
You can edit the following items:
1. Satellite: Press [Volume Up/Down] to
switch satellites or press [OK] to enter
satellite list to select directly.
2. LNB Configuration: Press [OK] to
enter LNB configuration, you will see a
window like beside:
LNB Type:
Press [Volume Up/Down]
to switch among “Standard”, “User” and “Universal” mode.
For Example: If you use a Dual LNB,
then you should select “User” option
in “LNB Type” and set the correct
frequency in LNB type.
22K:
Use [Volume Up/Down] to
switch “ON” and “Off”. The 22KHz
signal is used in KU universal LNBs to
change between low band and high
band.
!
Notice:
After choosing LNB type
“Universal” you cannot modify 22K.
DiSEqC1.0:
Use [Volume Up/Down] to switch the options of DiSEqC1.0
switches between Disable / LNB1 / LNB2 / LNB3 / LNB4.
DiSEqC1.1:
Use [Volume Up/Down] to switch DiSEqC1.1 option or press
[OK] to enter DiSEqC1.1 option to select directly. The options of this item
are: Disable / 1Cascade M1 Port1 / 1Cascade M1 Port2 / 1Cascade M1
Port3 / 1Cascade M1 Port4 / 1Cascade M2 Port1 / 1Cascade M2 Port2 /
1Cascade M2 Port3 / 1Cascade M2 Port4 / 1Cascade M3 Port1 /
1Cascade M3 Port2 / 1Cascade M3 Port3 / 1Cascade M3 Port4 /