Toshiba KV-PC 8GHO44-88 - Manual (Page 78)

65
6.3 PTZ Setup
The PTZ Setup allows you to enable PTZ cameras, create Presets, Tours, and also adjust speed settings. Many
options listed here are features only available on selected cameras.
RS485 / RS232 – Defines how to send the PTZ signal to the camera.
Select Camera – Selects the current camera to be edited.
Protocol – Selects the protocol to use for the selected camera. The protocol is the unique set of instructions
that allows the DVR to communicate with the PTZ camera.
Enable Pan/Tilt – Enables the DVR to control the PTZ camera.
Open PTZ Controller – This option opens the PTZ controller allowing you to move the PTZ camera.
On Screen Compass – This option allows on-screen PTZ Control. This allows you to move the PTZ camera by
simply clicking on the video itself instead of using the controller.
Preset and Tour – These options allow you to create Presets and Tours for the PTZ camera. Since each
camera creates these in a different way, there can be multiple ways to do this.
Pan Speed – This option increases or decreases the Pan speed.
Figure 6.3
1
2
3
4
5
6
7
8
1
8
2 4 5 7
13 Figure 6.3
PTZ Setup
3 6
9
10
11
12