Ariston MBZE 45 NF - Manual (Page 19)

19
GB
SHELVES: the shelves are
removable and their height may
be adjusted thanks to special
rails (see diagram), allowing easy
storage of large containers and
bulky food. The height may be
adjusted without removing the
shelf completely.
EVER FRESH: shelf dedicated
to storing food in vacuum-
packed containers. Food keeps
for longer when stored in the
containers provided.
CAN RACK shelf: stores cans
horizontally (see diagram).
Yoghurt, butter or general
containers may also be stored
here.
ODOUR FILTER * : some
models are fitted with a new
active carbon odour filter,
which ensures better air quality
inside the refrigerator.
The filter is located on the bottom
right-hand side, inside the
ventilation opening.
BAR COMPARTMENT:
Drinks stay cold and are easy to reach. The compartment
is designed to enable you to obtain bottles without having
to open the door of the refrigerator. It also provides a
handy surface when the door is open (maximum load 10
kg). The bottle shelf cover ensures the temperature inside
the refrigerator does not rise too quickly.
TEMPERATURE * Indicator
light: identifies the coldest
area in the refrigerator.
1. Check that OK appears
clearly on the indicator light (see diagram).
2. If the indicator light is completely black it means that
the temperature is too high: set the temperature of the
refrigerator compartment to a lower figure (see Using the
display) and wait approximately 10 hours for the air inside
the compartment to reach this temperature.
3. Check the indicator light again: if necessary, readjust it
following the above process. The indicator may also be
*
Available only in certain models.
completely black when large quantities of food are placed
inside or when the door is opened repeatedly. If this is the
case, set the temperature again (see Using the display).
! Any further adjustments to the temperature should be
carried out at 10 hour intervals, as this is the amount of
time needed for the temperature inside the refrigerator to
stabilise.
ICE TRAYS
The fact that they are situated on the top part of the
freezer drawers ensures greater cleanliness: the ice no
longer comes into contact with the food placed inside the
freezer compartment; furthermore, the dripping of the
water during filling is avoided (a lid to cover up the hole
after filling with water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with
water through the opening provided.
2. Take care not to exceed the level indicated (MAX
WATER LEVEL). Excess water prevents the ice cubes
from dispensing (if this happens, wait for the ice to
melt and empty the tray).
3. Turn the tray 90°: due to the connected compartments
each mould fills with water (see diagram).
4. Close the opening with the lid provided and put the
tray back.
5. When the ice has formed (minimum time approximately
8 hours) knock the tray against a hard surface and wet
the outside so that the ice cubes come loose and take
them out through the opening.
Accessories
1
2
ICE PARTY: ensures bottles of
sparkling wine or champagne reach
the right temperature. Place the
bottle in the bucket provided inside
the FREEZER and STORAGE
compartment. The bucket may be
used to serve the bottle and keeps
it cool outside the appliance.
WATER LEVEL
MAX
W A TER LEVEL
MAX
W
A
TER LEVEL
MAX