Topcom BUTLER 3055 User Manual
Page 157
ENGLISH
157
Butler 3055
157
157
157
157
157
157
157
157
157
157
157
157
4.25 Subscribing Butler 3055 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing mode,
you have to do the following to subscribe the handset:
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘BASE SUB’ appears on the display.
• Press the Programming key
.
• ‘BASE _‘ appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
• ‘SEARCHING’ and the symbol
appear on the display.
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
• Press the Programming key
.
• ‘PIN’ appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is ‘0000’). Use the number keypad.
• Press the Programming key
.
• The handset is subscribed to the base unit.
4.26 Subscribing a TOPCOM Butler 300 DECT GAP Headset
Make sure that the base pin-code is set to ‘0000’! See 4.23 for changing the base pin-code.
Press the Paging key
on the base unit for 10 seconds until the Line/charge indicator
on
the base unit starts to blink quickly. The line/charge indicator
will blink quickly for one
minute. During this minute, the base unit is in subscribing mode and you must do the follo-
wing to subscribe the headset:
- Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the
same time the red and green LED will lit ones.
- Remove the rubber cover of the power socket so that the hole of the power socket is free.
Pull out the rubber cover from the headset so that the registration key hole is free also.
- Press the headset registration key. The red LED will flash rapidly.
- If after a few seconds the green LED flashes slowly, the registration is successful.
- If the red LED flashes slowly, the registration is failed. Repeat above procedure and make
sure that the base pin-code is set to ‘0000’!
4.27 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset you are using to do the
cancellation procedure.
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
• Press the Programming key
.
HANDL. B3055_scan.qxd 5/5/03 10:44 pm Page 157