Tascam HD-R1 - Manual (Page 30)

30
TASCAM HD-R1
Specifications
Balanced Line Output
Connector XLR-3-32 (1:ground, 2:hot, 3: cold)
Impedance 100 Ω
Operating Level (adjustable) +4 dBu nominal / +24 dBu maximum
+4 dBu nominal / +22 dBu maximum
+4 dBu nominal / +20 dBu maximum
+4 dBu nominal / +18 dBu maximum
+6 dBu nominal / +15 dBu maximum
Unbalanced Line Output
Connector RCA
Impedance 100 Ω
Operating Level (adjustable) -10 dBV nominal / +10 dBV maximum
-10 dBV nominal / +8 dBV maximum
-10 dBV nominal / +6 dBV maximum
-10 dBV nominal / +4 dBV maximum
-8 dBV nominal / +1 dBV maximum
Headphones Output
Connector ¼” phone jack (tip: left, ring: right, sleeve: ground)
Minimum load impedance 32 Ω
Maximum level +4.7 dBu (at 1% distortion)
Maximum power 50 mW + 50 mW
Digital Input/Output
Connector Coaxial RCA phono jack
Impedance 75 Ω
Format S/PDIF (IEC 60958-2)
Quantization 16-bit or 24-bit
RS-232C
Connector 9-pin D-sub (female)
Clearance Accepts D-sub plugs with housings < 15mm high
Speed 9600 bps
Parallel
Connector 25-pin D-sub (female)
Clearance Accepts D-sub plugs with housings < 15mm high.
Input level 0 V to 3.3 V (logic low < 0.8 V, logic high > 2.0 V)
NOTE Inputs have internal pull-ups and can be activated by
shorting to ground.
Busy current loop rating 60 V DC (relay open), 1.5 A DC (relay closed)
LAN
Connector RJ45
Speed 10/100 Mbps
Format 100Base-TX (IEEE 802.3)
USB
Connector USB A-type 4-pin
Format USB 2.0
Power
AC input 100 VAC, 50/60 Hz
120 VAC, 60 Hz
230 VAC, 50 Hz
240 VAC, 50 Hz
In-rush current 700 mA
Power consumption 10 W