Toshiba RBC-AS21UL - Manual (Page 7)

Simple wired remote controller
Owner’s Manual
– 6 –
EN
3
HOW TO OPERATE INDOOR UNIT
„ COOL/HEAT AUTO ,
HEAT , DRY ,
COOL , FAN
Power supply
Turn on the power supply switch
12 hours before starting operations.
After the power supply has been
turned on, the operation of the remote
controller is not accepted for
approximately 1 minute. It is not a
failure.
(The sensor receives the signal once,
but the received contents are cleared.)
1
Push (ON/OFF) button.
2
Push (Mode) button to select
operation
to , , , or
.
3
Push (Fan Speed) button to
select fan speed mode.
When selecting , fan speed is
automatically changed.
(During FAN mode, the fan speed is
not automatically changed.)
4
Push either or to select
a desired temperature.
During FAN mode, the temperature
cannot be set up.
5
Stop
Push , (ON/OFF) button.
When using the remote controller to
stop the unit, the outdoor unit fan
may keep operating for a while even
if the compressor of the outdoor unit
has stopped.
• In heating, if the room is not
comfortably heated with FAN ,
select FAN or .
Although they are displayed, the
function may not be provided
depending on the using indoor unit.
(Fan speed is constant.)
• When the unit cannot be stopped
by the normal operation.
Turn off the power switch or circuit
breaker, and then contact the shop
which you purchased the unit.
3
2
1
5
4
6-EN
+01EN.BOOK Page 6 Thursday, October 8, 2009 3:37 PM