Troy-Bilt 682 User Manual

Page 28

Advertising
background image

Use a 3⁄8” wrench to remove the oil level check plug on the

left side of the transmission housing. See Fig. 6-6.

If the oil level is correct, oil will seep out of the check hole

(allow extra time in cold weather). If it does, the level is fine

and you should replace the check plug. If no oil seeps out

add oil as demonstrated in the Adding Oil Section on the

next page.

Tine Attachment Oil Level
NOTE: Two different gear oil checking procedures for the tine

attachment transmission are described next. Use the first

procedure if the dipstick in your tine attachment has only a

‘Check Cold’ marking. Use the second procedure if the dipstick

has both cold and hot markings at the end. First remove the

dipstick from the tine attachment transmission to see which type

dipstick you have. See Fig. 6-7. Then replace the dipstick with the

markings on dipstick facing to rear.

4.

5.

If tilling during very hot weather, the gear oil may heat up

and expand inside the transmissions. To allow for this oil

expansion, both the power unit transmission and the tine

attachment transmissions have oil relief vents. See Fig. 6-5.

The vents allow small amounts of oil to seep out.
If a serious leak is discovered, please contact your

authorized dealer or the Factory Technical Service

Department for service advice.

Checking Gear Oil Levels
Every 30 hours of operation, check the gear oil level in both the

power unit transmission and the tine attachment transmission.

Operating them while low on gear oil — even briefly — can

cause serious damage to internal components.

The transmissions must be cool, since hot gear oil expands

and gives a false reading.
The power unit transmission and the tine attachment

transmission must be connected when checking — or

adding — gear oil.
Move the tiller to level ground. Move the Depth Regulator

up so the tines rest on the ground.


1.

2.

3.

Gear Oil Dipstick

Back of

Tine Shield

Figure 6-

Oil Level Check Plug

Figure 6-6

Figure 6-5

Oil Vents

28

s

ectiOn

6— M

aintenance

& a

djustMents

Advertising