TANDBERG D13841.01 - Manual (Page 40)

TANDBERG 3G Gateway User Manual
40
Gatekeeper Settings
Gatekeeper Mode Enables the gateway to register to a Gatekeeper or without (direct mode).
Selecting direct will gray out the gatekeeper IP address settings. When
registered with a gatekeeper, the H.323 Gatekeeper Status shows
Registered, Gatekeeper
’
s IP address and what port used.
Selecting direct mode will result in no Gatekeeper registration; hence it is not possible to dial
through the Gateway via alias names. The H.323 Gatekeeper Status window will show
‘
Inactive
’
.
Problems with registration will be shown in the Status area and as a Red alarm on the
‘
Overview
’
page.
Gatekeeper IP Address
Enter the Gatekeeper IP Address that the gateway should register to. Leaving empty will result in
direct dialing without the use of aliases.
Authentication Mode
Off
Register to the Gatekeeper without authentication.
Auto Register to the Gatekeeper with H.235 authentication using ID/Password given below.
Authentication ID, Password
Enter the ID and password required to perform H.235 authentication at the Gatekeeper.
To register to a Gatekeeper that requires authentication, an NTP server has to be configured.
Note in case password is emty the gateway will still use the Authentication ID for registering
with the gatekeeper. In case Authentication ID is empty, the system name will be used for
registration.