Tyco 0-1591700-x - Manual (Page 14)

Wireless Access Point Model 0-1591700-x User Manual Page 14 of 33
Menu Systems
The access point supports 3 different menu presentations:-
• Web browser
• Telnet
• Serial Console
Each menu supports the same types of commands and controls. The web menu is a highly
graphical menu that is optimised for ease of usage whereas the Telnet and serial console menus
are command line interface type menus intended for more technical users.
Web Browser Menu
The web-based menu is a hierarchical menu of up to 3 levels in depth. The same basic hierarchy is
present on the Telnet and serial console interfaces. The options are:-
Top Level Menu Second Level Menu Third Level Menu
System > Administrator Settings Password
Idle Timeout
Remote Management
Firmware Upgrade > TFTP
Web
Configuration Tools > Restore Factory Default
Backup/Restore Settings
Status
Reset
LAN > LAN Settings IP Address
Enable DHCP Server
DNS Settings
DHCP Client List
Filtering > MAC Address Filtering
Wireless > .11a SSID, Channel, WEP,
802.1x Authentication
.11g SSID, Channel, WEP,
802.1x Authentication
Status
801.1x Status
SNMP > SNMP Community
SNMP Trap
Table 1 - Access Point Web Menu System
Serial Console Menu
This is obtained by using the supplied serial cable connected to a serial port on a PC. Select the
data rate of 9600, No Parity, 1 Stop Bit, No Flow Control. Press <Return> to view the log-in
screen. Windows or network service to obtain direct access to the menu system over the LAN
network. The interface is a command line system that is described in an application note on the
web site
www.lan-electronics.com
Telnet Menu
This is obtained by using the Windows or Telnet network service to obtain direct access to the
menu system over the LAN network. The Windows syntax is Start > Run > telnet 192.168.1.1
where the IP address is specific to your network. This user interface is a command line system that
is described in an application note on the web site
www.lan-electronics.com
PL0356 ©2003TycoElectronics Issue 1