Tyco Electronics MM23772 - Manual (Page 76)

MM23772, Rev. B
76
8.29.5 Scan Lockout Mode
Following the transmission or reception of a data call, if scan is enabled, scanning will stop temporarily
(two independent pre-programmed times; after a receive data call and after a transmit data call). During
this time the scan indicator will flash to indicate that scan is enabled but temporarily suspended. This
mode is normally exited when the pre-programmed time expires; however, the following actions will
terminate the scan lockout mode before the timeout is completed:
• The CLEAR button is pressed. The PTT is pressed.
• The group or system is changed.
• Phone call mode is entered.
• Individual call mode is entered.
• A new emergency assignment has been received.
• An emergency is declared or cleared.
•
An individual or phone call is received.
• An Agency, Fleet or System All Call is received.
•  or  is pressed to toggle Scan ON or OFF.
8.29.6 Data Lockout Mode
During the voice call scan hang time (pre-programmed) the radio will not receive data calls.