Thermador T24IW EN - Manual (Page 15)

15
Cleaning the
appliance
d WARNING d
To avoid electrical shock which
can cause death or severe
personal injury, disconnect power
to appliance before cleaning.
After cleaning, reconnect power.
d WARNING d
To avoid personal injuries or
property damage, observe the
following:
- Do not clean the appliance with
a steam cleaner.
- Do not let the water used for
cleaning drip onto the light or
control panel.
- Do not use abrasive or acidic
cleaning agents or solvents
which may damage the
surfaces of the appliance.
- Never clean shelves and
containers in the dishwasher.
The parts may warp.
q Switch off the appliance with
the POWER button!
Pull out the mains plug or
switch off the fuse.
q Clean the door seal with water
only and dry thoroughly.
q Clean the appliance with
lukewarm water and a little
dishwashing liquid.
Do not let the water used for
cleaning drip onto the control
panel or light.
q Check the ventilation openings
on the base panel. Remove dirt
with a vacuum cleaner.
After cleaning:
q Reinsert the mains plug or
switch on the fuse. Switch on
the appliance with the POWER
button.
i Have your supplier inform you
about special cleaning and care
information for appliance
surfaces.
q Wipe appliance surfaces with a
damp cloth.
Then immediately wipe dry.
Odors
If the appliance is emitting
unpleasant odors:
q Switch off the appliance with
the POWER button!
q Clean the interior.
See section on Cleaning the
appliance".
q Check the odor filter.
See section on Changing the
filter".
q Thoroughly clean all packing
containers used in the
appliance.
q Switch on the appliance again
with the POWER button.
q After 24 hours check whether
the odors have been eliminated.
Warning
messages
via the display
If several warning messages are
displayed simultaneously, deal with
each message individually.
While a warning message is
displayed, buttons cannot be
pressed.
11.
Door alarm
Cause
- An appliance door has not been
closed properly or has been
open too long.
Remedial action
q Close the door.
The display goes out.
Sensor fault
Cause
- A technical defect is possible.
E01 = defect in the top
compartment
E02 = defect in the bottom
compartment
Remedial action
q Conduct an appliance selfĆtest.