Thermador DOWNDRAFT HDDW 36DS - Manual (Page 9)

PAGE 7
Step 5: INSTALLATION
This hood is intended to be mounted onto the kitchen
wall.
1. Remove the grease filter (refer to Operating
Instructions).
2. Draw a line on the wall from the ceiling to the lower
edge of the hood at the center of the location where
the hood is going to be mounted.
3. Use the template to mark the points on the wall where
the screws will be mounted. In order to make it easier
to hook the hood onto the screws, draw the outline of
the area where the hood will be attached.
ṇ
CAUTION – Ensure that the minimum distance
between the cooktop and the hood is maintained – 30”.
The bottom edge of the template equates to the lower
edge of the hood.
4. Drill 2x 1 /
4
” ø holes for the upper fixing bracket and
2x 1 /
4
” ø holes for the lower fixing bracket and press in
wall plugs flush with the wall.
Note: At least one screw for the mounting must be
installed through a stud.
6. Attach the hood.
Adjust the height and align horizontally with the
adjusting screws.
IMPORTANT: Check that the 4 lower fixing holes have
been correctly marked. If required, mark again.
Step 5: INSTALLATION
Note: Take into account any special
accessories that are going to be fitted.
5. Screw on the upper and the two lower mounting
brackets.